In many cases, after we purchase the LED display , it will not be installed immediately due to some factors. In this case, the full-color LED display must be stored well. As a precision electronic product, the full-color LED display has high standards for storage methods and environment. Carelessness will cause damage to the full-color LED display. Now let’s take a look at how to store it correctly. Full color LED display.
Share precautions for saving LED displays
When saving a full-color LED display, you must pay great attention to the following eight points:
(1) The place where the box is to be placed needs to be cleaned and paved with pearl cotton.
(2) It is strictly forbidden to stack modules in a messy manner or stack more than 10 modules on the full-color LED display. When the modules are stacked, the lamp surfaces are placed opposite each other and separated by pearl cotton.
(3) When placing the full-color LED display box, it is recommended to place it flat with the lights facing up. If the number is too large and must be placed vertically, special care must be taken to protect it. It is strictly prohibited to place it vertically in places with great vibration.
(4) The full-color LED display box should be handled with care. When landing, the rear side should first touch the ground and then the light surface to prevent bumps.
(5) All workers must wear cordless anti-static bracelets during installation or maintenance.
(6) The full-color LED display screen is installed with an anti-static bracelet
(7) The box should be lifted when loading and unloading, and should not be pushed or dragged away on the ground to prevent damage to the bottom module caused by uneven ground. The box should remain balanced during the lifting process and should not sway left or right in the air or rotate. When installing the box or module, handle it with care and do not throw it.
(8) If the full-color LED display product must be adjusted, use a soft rubber hammer to hit the metal part of the box. It is strictly prohibited to tap the module. Extrusion, collision, etc. between modules are strictly prohibited. When there are gaps or abnormal positioning, it is strictly forbidden to tap the box and module with hard objects such as hammers. You can pick up the box and remove impurities before trying again.